AnswerHardware
What overhang angle needs support?
Past 45° from vertical, by the 45° rule. Bambu Studio's 30° and PrusaSlicer's 35° count from horizontal (60°, 55° from vertical); Cura's 50° counts from vertical.
AnswerHardware
Past 45° from vertical, by the 45° rule. Bambu Studio's 30° and PrusaSlicer's 35° count from horizontal (60°, 55° from vertical); Cura's 50° counts from vertical.
AnswerHardware
Yes: up to 45° by most design guides (Prusa says 45 to 60°) and across bridges of 5 to 10 mm. Past that, use chamfers, teardrop holes, splits or a new orientation.
AnswerHardware
Temporary structures the slicer builds under steep overhangs, long bridges and mid-air islands. Off by default; Bambu Studio supports surfaces under 30° from horizontal.
AnswerTroubleshooting
Each overhang layer rests partly on air; past about 45° from vertical, soft plastic sags before it cools. Fix: full fan, slower overhangs, a cooler nozzle.